 |
K & N UNIVERSAL ROUND STRAIGHT TYPE AIR FILTERS
|
|
|
|
- F = INSIDE FLANGE DIAMETER
This is the most critical dimension and should be very close to the diameter of the application inlet flange. The K & N filter will stretch about 1/8’’ for those odd sizes. - FL = FLANGE LENGTH AND ANGLE
If no length is listed it will approximate 5/8’’ long. The angle is listed in degrees and helps to position the filter when space is a problem. - D = DIAMETER
This is the overall diameter of the filter. Always use the largest diameter practicable to insure maximum filtration. - L = LENGTH
This dimension does not include the flange length - only the body. Always use the longest filter practicable for maximum filtration. - O = OFFSET
Sometimes the flange is offset to one edge of the filter.
Note: See chart for any applicable footnotes.
Application Chart
|
|
|
|
